<p>The LSP EMT Resuscitator is today’s most advanced design in oxygen powered manually triggered breathing devices. Designed to deliver 100% oxygen to a breathing or non-breathing patient, the EMT Resuscitator provides emergency care professionals with greater versatility, increased safety and improved performance over existing hand-held devices.<br /> <br /> Designed to operate with a regulated oxygen supply of 50±5 psig (344±34 kPa), the EMT Resuscitator immediately terminates both pressure and flow at 60 cm H2O. As a secondary pressure safeguard, if the primary pressure limit is exceeded for any reason, the secondary spring-loaded relief valve is designed to prevent pressure from exceeding 80 cm H2O. The EMT Resuscitator may be attached to a portable pressure-regulated oxygen cylinder or a central oxygen source. It may be used with a mask, endotracheal tube or tracheotomy tube.<br /> <br /> Advanced pneumatic technology limits and regulates gas flow to 40 lpm during the manually-triggered breath, but will allow flow rates of up to 115 lpm during a spontaneous breath. Addressing AHA guidelines, the EMT Resuscitator delivers a constant pre-set flow of 40 lpm, reducing the possibility of gastric insufflation during mask ventilation and improving the distribution of gas throughout the lung when ventilating through an endotracheal or tracheotomy tube.<br /> <br /> The EMT Resuscitator features built-in anti-asphyxiation ports that allow the patient to breathe outside ambient air in the event of source gas failure. In addition, a 360° swivel oxygen inlet attachment eliminates the problem of line twisting and tangling.<br /> <br /> <b>KEY FEATURES:</b><br /> Easy to clean and service … disassembles into three basic components for cold chemical disinfecting and reassembly<br /> Versatile … provides administration of low flow oxygen and/or oxygen powered resuscitation.<br /> Durable, compact and lightweight for years of continual cost-effective performance<br /> <br /> SPECIFICATIONS</p> <p>Supply Pressure: 50±5 psig (344±34 kPa)</p> <p>Pressure to Initiate a Breath: 0 to -2.5 cm H2O</p> <p>Manually Triggered Flow: 40±5 lpm @ 50 psig (344 kPa) supply</p> <p>Demand Flow: 100 lpm @ 0 to -5 cm H2O pressure</p> <p>Peak Demand Flow: 115±10 lpm @ 50 psig (344 kPa) inlet; -5 cm H2O or less to obtain 100 lpm</p> <p>Pressure Limit: 60±5 cm H2O</p> <p>Secondary Pressure Relief: 65-80 cm H2O maximum</p> <p>Expiratory Resistance: less than 2.5 in. (6.35 cm) H2O @ 160 lpm flow</p> <p>Anti-Asphyxiation Entrainment: 55 lpm minimum @ -5 cm H2O pressure</p> <p>Storage Temperature: -40° F to 160° F (-40 C to 71.1 C)</p> <p>Operating Temperature: -30° F to 125° F (-34.4 C to 51.7 C)</p> <p>Inlet Fitting: standard male oxygen DISS (swivel)</p> <p>Filter: 25 micron wire mesh</p> <p>Outlet: 22 mm outside diameter x 15 mm inside diameter</p> <p>Materials: Body, cap & button - liquid crystal polymer; outlet - polysulfone; inlet fitting - plated brass</p> <p>ORDERING INFORMATION</p> <p>L576 EMT Resuscitator</p> <p>L576-010 EMT Resuscitator with 6' (1.8 m) oxygen hose</p> <p>L576-020 EMT Resuscitator with 6' (1.8 m) oxygen hose, adult cuffed mask</p> <p>L099-004 Adult Cuffed Mask, reusable, size 4</p> <p>L099-005 Adult Cuffed Mask, large, reusable, size 5</p> <p>L535026 Oxygen Hose, 6' (1.9 m), with DISS fittings</p>